Research Article
Phase Equilibria Calculation and Investigation of Hardness and Electrical Conductivity for Alloys in Selected Sections of Bi-Cu-Ni System
Branislav R. Markovic1*, Dragana T. Živkovic2, Dragan M. Manasijevic2, Nadežda M. Talijan3, Miroslav D. Sokic1 and Vladan R. Cosovic3
1Institute for Technology of Nuclear and Other Mineral Raw Materials, Serbia
2Technical Faculty, University of Belgrade, Serbia
3Institute of Chemistry, Technology and Metallurgy, Serbia
- *Corresponding Author:
- Branislav R. Markovic
Institute for Technology of Nuclear
and Other Mineral Raw Materials
86 Franchet d’Esperey Street
Belgrade 11000, Serbia
E-mail: b.markovic@itnms.ac.rs
Received Date: November 24, 2012; Accepted Date: December 17, 2012; Published Date: December 23, 2012
Citation: Markovic BR, Živkovic DT, Manasijevic DM, Talijan NM, Sokic MD, et al. (2012) Phase Equilibria Calculation and Investigation of Hardness and Electrical Conductivity for Alloys in Selected Sections of Bi-Cu-Ni System. J Powder Metall Min 2:104. doi: 10.4172/2168-9806.1000104
Copyright: © 2012 Markovic BR, et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Abstract
The results of phase equilibria calculation and the experimental investigation of alloys in selected sections of Bi-Cu-Ni system with bismuth constant molar content of 0.6; 0.7; 0.8; and 0.9 are presented in this paper. Thermodynamic calculation was done according to the CALPHAD method using PANDAT software, while chosen alloys in the selected sections were experimentally investigated using hardness and electrical conductivity measurements.
