Editorial
Pore Size Controlling in PM Alloy Parts
Yuanzhi Zhu1* and Yingying Guo2
1School of materials and metallurgy, Wuhan University of Science & technology, China
2Key Laboratory for Ferrous Metallurgy and Resources Utilization of Ministry of Education, Wuhan University of Science and Technology, China
- *Corresponding Author:
- Yuanzhi Zhu
School of materials and metallurgy
Wuhan University of Science & technology, Wuhan 430081, China
E-mail: tozyz1@163.com
Received Date: August 16, 2012; Accepted Date: August 17, 2012; Published Date: August 21, 2012
Citation: Zhu Y, Guo Y (2012) Pore Size Controlling in PM Alloy Parts. J Powder Metall Min 1:e103. doi: 10.4172/2168-9806.1000e103
Copyright: © 2012 Zhu Y, et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Abstract
Pores are important characteristics in powder metallurgy alloy parts. The effect of processing parameters on pore size is discussed. If pore size can be controlled as small as several or tens of nanometers in PM alloy parts, the parts may gain special physical or mechanical properties. The challenge to obtain pores sizing in several or tens of nanometers in PM alloy parts is discussed.
